5 Most Common Mistakes People Make In Selecting The Right Lubricant Manufacturing
In
today's world, lubricants are used in everything from cars to cell phones. In
the simplest terms, a lubricant is anything that decreases friction. That being
said, not all lubricants are created equal and selecting the right one is
crucial for performance and long-term health of your equipment. Here are 5
mistakes people make when selecting the right Lubricant
Manufacturers in India that you should avoid.
1.
Failing to understand the differences between greases and oils.
Many
people assume all lubricants are one in the same, but this is not true. Oils
are generally clear liquids whereas grease is usually thick and opaque. Many
people don't know or forget that grease comes in both petroleum base and
synthetic-based. Oils are more often than not thinner, while greases offer
necessary thickening agents to achieve required viscosity levels. There is a
time and place for both oils and greases in accordance with what you're trying
to lubricate.
2.
Not doing your home work on the specific equipment manufacturers needs.
It's
important to find out what the equipment manufacturer recommends in terms of
lubricant before specifying products to be used on your jobsite. Failing to do
so could lead to costly down time and repairs caused by incompatible products,
which leads me right into my next point.
3.
Focusing too much on price and not on performance, durability or compatibility.
Many
people are under the assumption that the lowest price oil or grease is always
best for their application. This couldn't be further from the truth! Many times
products of lesser cost lack proper additives which leads to more wear on
equipment and poor protection of components. If you have experience with
lubricant manufacturers, you know that it is typically the higher priced oils
and greases that perform better, offer protection even in extreme temperature
conditions, and provide lubrication over a longer period of time.
4.
Failing to specify environmental conditions and type of equipment to be used.
It's
important to understand the harshness of the environment you'll be working in.
For example, will your equipment be exposed to extreme cold or hot
temperatures? Is it used on the surface of the Earth (low gravity), such as on
a satellite, or even worse, is it used beyond our terrestrial sphere (high
gravity)? Knowing these answers can help you choose more appropriate products
and help you avoid costly trial and error.
5.
Not specifying the right viscosity levels for your job.
This
is crucial because many Lubricant
Manufacturers in India don't even know how to properly fill their
containers with product! A common mistake that some lubricant manufacturers
make is filling containers with product up to the neck which leaves little room
for expansion caused by temperature changes or vacuum created upon start up.
This creates excessive pressure when the product is dispensed through the
spout! A good manufacturer will fill their container to around 80-90% of
capacity leaving room for expansion where a bad one will fill theirs all the
way to the top.
The
wrong viscosity level can cause poor performance and even more costly repairs
if your equipment is exposed to extreme environmental conditions.
Original Source Content -
Comments
Post a Comment